Escrito originalmente por RikoRocket en 29 de Noviembre del 2007
M1K3LSlot ----- YES power adjustable to S curve.
DAVIDNENE escribió:The optional "Rally" and "persecution" are now written into the new software? Sorry, No not yet. We concentrate on bug fix and getting two way aux link 100%.There are some manual Slotforum how to update PB with the cable Richg? Guess who put on the new site that are going to do, really? It will happen
Corrected bugs in min and max throttle set up. ;
; ;
; Corrected bug in number of laps and duration setup where if ;
; ls 2 digits equalled the ms 2 digits number of laps selected ;
; were incremented by 1 (was trying to ensure that 0 laps ;
; couldn't be selected. ;
; ;
; Start timing modified to match the SSD, Lap Count tower and ;
; third party software start timing. ;
; ;
; PC rx modified so that Aux In commands do not write to EEPROM ;
; instead write direct to RAM. Hence PC setup is not saved on ;
; the powerbase so need to resend race setup for each new race. ;
; Benefit is that Aux In commands can be received during a race.;
; ;
; In GPrix and Endurance race modes cars running are no longer ;
; determined when the lead car completes it's first lap. For ;
; GPrix mode cars running is set when the lead car finishes, ;
; for Endurance there is no need as all cars are stopped when ;
; race time has expired. For pursuit mode cars running is still ;
; set when the lead car completes it's first lap. ;
; ;
; Track call now also released by pressing the brake and LC ;
; buttons on the throttle. ;
; ;
; For race modes display confirmation of each car starting on ;
; LCD line 2 until the lead car completes its first lap. ;
; ;
; CONFIG Setting for minimum lap time added, from 0 to 63 secs. ;
; ;
; CONFIG Setting for maximum lap time for pace car random lane ;
; change added, from 0 to 63 secs. ;
; ;
; Default min throttle changed to 02h and default max throttle ;
; changed to 3Ch ;
; ;
; Power level display changed to percentages and power level ;
; settings now effective for throttle maps as well. Throttle ;
; map selection moved under hand throttle setup. ;
; ;
; Bug in writing default EEPROM values to addresses 80h to FFh ;
; corrected - this bug had caused the throttle map to ;
; malfunction for throttles 3 to 6. ;
; ;
; Fine tuning of pace car speed can now be selected with the ;
; brake button as well as the Set button. ;
; ;
; Power to the pace car is now enabled for manual speed adjust. ;
; ;
; The cars_running parameter is now cleared when a race is ;
; stopped via the Set button or a PC Aux In command. ;
; ;
; Race pause (PC and PB Start button initiated) and track call ;
; (throttle initiated) merged, both now being known as track ;
; call and both suspending timers and lane sensing after 2 secs.;
; Throttle track call can now have a programmed delay between ;
; 0 and 4 secs whilst PC and PB track calls action immediately. ;
; Race is not suspended for slow speed track call. ;
; ;
; Overload also retains timers and lane sensing operational for ;
; 2 secs after being initiated.
). Pero si vale lo mismo creo que me esperare mas adelante, ya me he dejado bastante pasta en 1 mes 
